4in1 Designer Pop Socket Mould

Make your own custom phone grips at home with this 4-in-1 Designer Pop Socket Mould — a silicone mould set that lets you cast four different pop socket shapes in a single pour. Whether you use UV resin, epoxy resin, or air-dry clay, this mould gives you clean, detailed results with easy demoulding every time.

Perfect for hobbyists, small resin businesses, and anyone looking to personalise phone accessories or sell handmade pop sockets. Each cavity produces a ready-to-glue pop socket top that pairs with standard pop socket bases available separately.

• 4 designs in one mould — cast four different pop socket shapes in a single session to maximise your resin pours
• Compatible with UV resin and epoxy resin — works with most casting resins, pigments, glitter, and dried flowers
• Flexible silicone construction — pieces pop out cleanly without cracking or distorting the design
• Smooth finish cavities — produces a glossy, polished surface on the cast side that faces up in the mould
• Beginner-friendly size — compact cavities sized to fit standard pop socket bases for a secure glue-on fit
• Great for gifting and reselling — create personalised phone grips with inclusions, resin art, or custom colours
• Reusable and easy to clean — rinse with water after use; avoid sharp tools inside the cavities to extend mould life

How to Use

Mix your UV or epoxy resin as per the manufacturer's instructions. Add pigment, glitter, or inclusions as desired. Pour into the mould cavities, remove air bubbles with a toothpick or heat gun, then cure under a UV lamp or allow epoxy to fully set. Once cured, flex the mould gently to release the pieces. Sand edges lightly if needed, then glue onto a pop socket base using strong adhesive.

Safety Tips

Always work with resin in a well-ventilated area and wear gloves to avoid skin contact. Uncured resin is a skin irritant — keep away from children. UV resin requires UV lamp exposure for full cure; epoxy resin requires accurate mixing ratios for a hard, non-tacky finish. Store the mould flat, away from direct sunlight, to prevent warping.