Heart Hanging Photo Frame Mould

Create personalised heart-shaped photo frames using epoxy or UV resin with this Heart Hanging Photo Frame Mould from Shrebhavi. The mould is designed with a built-in hanging slot, so your finished piece is ready to display straight out of the cast — no extra hardware needed.

Ideal for gifting, home décor, and small resin businesses, this mould lets you embed photos, pressed flowers, glitter, or pigments inside a classic heart shape. Made from flexible silicone, it releases cured resin cleanly without tearing or distorting the frame edges.

• Heart shape with hanging slot: Cast a ready-to-hang frame in one pour — no drilling or extra fittings required.
• Flexible silicone construction: Cured resin pops out easily without cracking or sticking to the mould surface.
• Compatible with epoxy and UV resin: Works with most casting and UV resins available in India.
• Embed anything you like: Photos, dried flowers, foils, glitter, pigment powders, and charms all sit beautifully inside the frame.
• Reusable and easy to clean: Rinse with water after use; silicone resists resin build-up for multiple casts.
• Perfect for gifts and small businesses: Make custom keepsakes, wedding favours, or personalised wall décor at low cost per piece.
• Beginner-friendly design: Simple flat pour with clear edges — a great starter project for new resin artists.

How to Use

Place your photo or decorative elements face-down in the mould cavity. Mix your epoxy resin as per the manufacturer's ratio, pour slowly to avoid bubbles, and allow to cure fully before demoulding. For UV resin, pour in thin layers and cure each layer under a UV lamp before adding the next.

Safety Tips

Always wear nitrile gloves and work in a well-ventilated area when handling uncured resin. Keep resin away from children and pets. UV resin requires UV lamp exposure to cure — do not use it as a substitute for two-part epoxy in deep pours.