Resin 2:1 (300gm)

The Shrebhavi 2:1 Epoxy Resin (300gm) is a two-part casting and coating resin mixed at a 2 parts resin to 1 part hardener ratio by weight. Designed for hobbyists, artists, and small-batch creators, this pack gives you enough material to complete jewellery pieces, coasters, small trays, or decorative castings without committing to a large quantity.

The cured finish is crystal clear, making it ideal for embedding flowers, glitter, pigment powders, alcohol inks, and foils. Whether you are just starting out with resin art or restocking for a specific project, this 300gm pack is a practical, affordable choice that stores well when sealed properly between sessions.

• 2:1 mix ratio by weight — 200gm resin + 100gm hardener; use a digital kitchen scale for accurate results
• Crystal clear cure — low yellowing formula suitable for jewellery, coasters, trays, and embedding projects
• Beginner-friendly pack size — 300gm total is ideal for 2–4 small projects or testing new techniques without waste
• Compatible with common additives — mix with alcohol inks, mica pigments, resin dyes, dried flowers, or glitter
• Moderate working time — allows time to add colour, remove bubbles with a heat gun or torch, and pour into moulds before curing begins
• Versatile use — suitable for silicone moulds, open bezels, geode art, resin paintings, and small decorative castings
• Resealable bottles — store unused resin and hardener separately in a cool, dry place away from direct sunlight

How to Use

Measure 2 parts resin to 1 part hardener by weight using a digital scale. Combine in a clean mixing cup and stir slowly for 3–4 minutes, scraping the sides and bottom. Pour into your mould or bezel and use a heat gun or lighter held 10–15 cm away to pop surface bubbles. Allow to cure undisturbed at room temperature (ideally 25–30°C) for 24–48 hours before demoulding.

Safety Tips

• Always wear nitrile gloves and work in a well-ventilated area — uncured resin and hardener can irritate skin and eyes
• Keep out of reach of children and pets
• Do not pour unmixed or excess resin down the drain — allow waste resin to cure fully before disposal
• If skin contact occurs, wash immediately with soap and water; avoid using solvents on skin