Resin 3:1 (1.2kg)

Shrebhavi 3:1 Epoxy Resin is a two-part, crystal-clear casting and coating resin ideal for resin art, jewellery making, coasters, trays, and decorative pours. The 1.2kg pack (split as Part A resin and Part B hardener in a 3:1 mix ratio by weight) gives you enough material for multiple medium-sized projects without wastage.

Designed for Indian hobbyists and small-batch creators, this resin cures to a hard, glossy, water-clear finish with minimal yellowing over time. Its relatively low viscosity makes it easy to mix, pour, and work with pigments, inks, dried flowers, and glitter. Always wear gloves and work in a ventilated area — uncured epoxy resin is a skin and eye irritant.

• 3:1 mix ratio by weight — precise and easy to measure with a digital kitchen scale for consistent cures every time
• Crystal-clear finish — cures to a high-gloss, water-clear surface that showcases pigments, inclusions, and embedments beautifully
• 1.2kg pack size — enough for coasters, small trays, jewellery pieces, or multiple art pours in one purchase
• Low viscosity formula — pours and self-levels smoothly, helping reduce trapped air bubbles in your finished piece
• Compatible with resin pigments, alcohol inks, mica powders, and glitter — works with most standard resin colourants available in India
• Suitable for silicone moulds and open pours — use for casting jewellery, decorative objects, coasters, and small tabletop art pieces
• Hard, durable cure — finished pieces resist scratches and moisture when fully cured, making them suitable for everyday decorative use

What's Included

1.2kg total pack containing Part A (resin) and Part B (hardener) in the correct 3:1 ratio by weight. No additional components included — you will need a digital scale, mixing cups, stir sticks, gloves, and silicone moulds or a surface to pour onto.

How to Use

Measure Part A and Part B by weight in a 3:1 ratio (e.g., 90g resin to 30g hardener). Mix slowly and thoroughly for 3–5 minutes, scraping the sides and bottom of the cup. Add pigments or inclusions if desired, then pour into your mould or onto your surface. Use a heat gun or lighter held at a distance to pop surface bubbles. Allow to cure at room temperature (ideally 25–30°C) for 24–48 hours before demoulding. Full hardness is typically reached in 72 hours.

Safety Tips

Always wear nitrile gloves and safety glasses when handling uncured epoxy resin. Work in a well-ventilated space or use a respirator mask. Keep away from children and pets until fully cured. Avoid skin contact — if resin touches skin, wash immediately with soap and water. Do not pour uncured resin down the drain.